So apparently I managed to lose the gasket(s) that go on both sides of the fuel inlet banjo.
Any idea on part number/sizes? Are they both the same?
I remember them being copper when I took them off. Are they just a flat washer or were they those copper crush washers?

Thanks!

 

They are crush washers. Go to your local autoparts store and pick up a few assorted sizes in the HELP section or here is the part number:

90430-12026 GASKET(FOR FUEL PIPE SUPPORT) $1.15

 

Thanks!
I went to Autozone locally and they didn't have ANY copper crush washers!

Checking NAPA next.

 

Autozone should have had the gaskets. They're not behind the counter, they're in the HELP! section of the store.

 

I looked but couldn't find anything. Then I asked the guy behind the counter and he showed me regular steel washers.

 

Apparently the banjo bolt itself is screwed up and I need to find another solution. The copper washer wasn't seating evenly. Good time to bypass the fuel dampener?

Edit:
You can use banjo bolt crush washers from brake lines. They fit and seal fine.