drewdizzle

iTrader: (4)

first: the car is a 92 sc300. I am installing a soarer 1jzgte with r154 transmission.

I am looking through my repair manual and it says to check the propeller shaft joint angle on instalation. now I have a couple of questions.

1. I am putting on a mk3 half shaft. so the front part of the drive shaft is a different length. that will throw the angle off. correct? or is it relative to the no. 1 drive shaft angle?

2. what is the correct angle for the no 2 and no. 3 joints?

3. is there a place i can rent the sst 09370-50010 (drive line angle tool)?