Rerouting Driver Side Harness
#1
Rerouting Driver Side Harness
Im trying to reroute the wiring harness that is right underneath the driver side fender. I took a look yesterday and it looked like all I had to do was unplug a few connectors in the footwell by the clutch pedal and remove the 2 10mm bolts in the fenderwell. I then began to tug on it to see if I can get it out but there seemed to be another series of wires that ran right behind the fuse panel in the driver side footwell by the clutch pedal. Now my question is, how would I be able to get to this series of wires which is most likely attached to 1 connector? Ive already removed the 4 connectors attached to the harness but apparently I missed 1 more but cant really get to it. Any advice would help. Im tired of my tires cutting through the harness at every bump. Thanks!
#2
Pole Position
iTrader: (1)
Join Date: Feb 2007
Location: Florida
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
I started to do this also, but what I did was get some additional wire loom and zip tie it above the lip in the fender well. I ride very low and haven't had any problems hitting that anymore. Not what you asked for, but just a suggestion.
#3
I did that on my brother's SC. I just lowered his but not to a full slam yet. Still rubs while make a turn and hitting a dip at the same time. I'd try that myself but Im going to be going super low with my wheels pushed out. Im already stretching just to clear the rolled fender.
Thread
Thread Starter
Forum
Replies
Last Post
SynicalVip
LS - 1st and 2nd Gen (1990-2000)
11
11-27-12 09:55 PM
rpx13
Lexus Audio, Video, Security & Electronics
1
10-15-08 10:17 AM