removed pre-cats?
#2
Lexus Test Driver
Join Date: Nov 2006
Location: Georgia
Posts: 1,002
Likes: 0
Received 0 Likes
on
0 Posts
yea i think so
some guy deleted all but center one and put in an "x" pipe there all custom 3" piping
3" w/o a turbo though doesn't sound good
HE SAID it turned out good, i didnt get any specific stat changes
some guy deleted all but center one and put in an "x" pipe there all custom 3" piping
3" w/o a turbo though doesn't sound good
HE SAID it turned out good, i didnt get any specific stat changes
#4
Banned - could not follow forum rules
Join Date: Oct 2005
Location: CA
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
I have, what do you want to know?...I deleting the precats and I also used the magnaflow 2 into 1 center cat with the built in high flowing Y design...Good improvement in power was noticed at higher rpms from both changes......Deleting all cats and installing a highflowing X design would be the best option for performance, but say goodbye to passing smog emissions...
#6
Banned - could not follow forum rules
Join Date: Oct 2005
Location: CA
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
Well you can ditch the pre-cats and install two single high flowing cats and locate them else where on the exhaust system..Custom down pipes will need to be fabed..It maybe hard to find exact fitting replacements...Search I think I read somewhere about replacement high flowing precats from Magna flow......
I do know you need all three to pass emission here in California where I live..The one main high flowing center cat is not enough to pass......
I do know you need all three to pass emission here in California where I live..The one main high flowing center cat is not enough to pass......
Trending Topics
#8
Banned - could not follow forum rules
Join Date: Oct 2005
Location: CA
Posts: 1,020
Likes: 0
Received 0 Likes
on
0 Posts
Too much...$700 for the S&S Headers, $400 for the prefabed down pipes, $300 for entire intallation.....$1300 total for the headers installed and alot of fitting headaches.... If I were to do it all over again I would have paid $900 for the EKtuning.com headers...Atleast they are a direct bolt on header as apposed to the S&S's.....
Thread
Thread Starter
Forum
Replies
Last Post