Windshield replacement missing moulding?
Thread Starter
Driver School Candidate
Joined: Mar 2018
Posts: 2
Likes: 0
From: Florida
Windshield replacement missing moulding?
I had the windshield replaced on my 2017 NX 200t and wanted to confirm if the moulding in the top left (passenger) corner looks correct.
I can see a copper colored piece of "wire" sticking out of the rubber moulding (circled in red), while the top right (drivers) corner appears to be flush.
I also wanted to confirm if this is an OEM windshield.
Thank you
I can see a copper colored piece of "wire" sticking out of the rubber moulding (circled in red), while the top right (drivers) corner appears to be flush.
I also wanted to confirm if this is an OEM windshield.
Thank you
Intermediate
Joined: Apr 2017
Posts: 314
Likes: 83
From: Vancouver, USA
I had the windshield replaced on my 2017 NX 200t and wanted to confirm if the moulding in the top left (passenger) corner looks correct.
I can see a copper colored piece of "wire" sticking out of the rubber moulding (circled in red), while the top right (drivers) corner appears to be flush.
I also wanted to confirm if this is an OEM windshield.
Thank you
I can see a copper colored piece of "wire" sticking out of the rubber moulding (circled in red), while the top right (drivers) corner appears to be flush.
I also wanted to confirm if this is an OEM windshield.
Thank you
Suggest you take it to your dealer or whoever did the work so they can make it right....
Last edited by DampDuffer; Mar 2, 2018 at 12:19 PM.
Thread Starter
Driver School Candidate
Joined: Mar 2018
Posts: 2
Likes: 0
From: Florida
My Lexus dealer replaced my 2017 NX windshield with another OEM windshield (actually, they subbed-out the job), and it appears to be the same windshield you now have, BUT IT DOES NOT HAVE THE GAP/MISSING MOLDING that yours has.
Suggest you take it to your dealer or whoever did the work so they can make it right....
Suggest you take it to your dealer or whoever did the work so they can make it right....
I looked at a Lexus NX windshield installation video, and I believe the part of the moulding with the wire showing (circled in photo) is attached to the windshield itself and may have broken off prior / during the installation.
Safelite did the installation, so I may check with them to see what can be done.
Thread
Thread Starter
Forum
Replies
Last Post
samr10
GX - 1st Gen (2003-2009)
8
May 16, 2018 06:57 AM