Good day everyone . I have a 2017 NX and wanted to verify the vibration and find out that both my passenger wheels are bent from top bottom and not side to side. When car was lift up and verification done after going back on the road. THE VSC light was on and the Hold On button light was continuously flashing. I tried to remove it with the VSC switch and the old on button. No luck, I disconnected the battery for 15 minutes and still on, I disconnected it again all night and verify back in the morning and light still on. I believe the only way to get these light out is to put it on a OBD computer to take out the codes. Has anyone ever had this problem and what was the fix?

Thanks and have a great day

 

Did you ever solve?

 

I had to go to a garage and get a computer reset in order to take out the flashing light.