New Build! 1999 LX470
The following users liked this post:
tlhicks (03-09-18)
#78
Driver
Thread Starter
#79
Driver
Thread Starter
#80
Lexus Test Driver
iTrader: (31)
Join Date: Aug 2006
Location: All Around Our Nation's Capital
Posts: 1,354
Likes: 0
Received 6 Likes
on
6 Posts
I'm going to start with Herculiner paint on truck bed liner, use metal edging on the top front and sides for protection and to straighten up the edges a bit, then most likely carpet or rubber line the inside of the drawers, and then I have a few ideas for the drawer front but I'm not locked down on that yet. I was going work on it today after work but I forgot to bring the Herculiner with me.
#81
Driver
Thread Starter
I have made significant progress on my storage drawer build this week. I got the driver side wheel well covers completed. Two section are removable. Giving me access to my compressor and additional storage. I have a 360 degree swivel Air compressor outlet and the control for the 3000 watt inverter built into it.
The following users liked this post:
tlhicks (04-06-18)
#83
Lexus Test Driver
iTrader: (31)
Join Date: Aug 2006
Location: All Around Our Nation's Capital
Posts: 1,354
Likes: 0
Received 6 Likes
on
6 Posts
Looking better and better. I have a few more parts that came in for my drawer build and I'll post up info once complete.
Our builds are going along similar paths and timelines.
If only we lived close to each other.
There would be a garage night every night
Our builds are going along similar paths and timelines.
If only we lived close to each other.
There would be a garage night every night
#84
Driver
Thread Starter
Dude that would be awesome.
#85
Driver
Thread Starter
So I have actually completely finished my storage and drawer build. Today I completed the wheel wells. Added a lock to the drawer, and installed recessed anchor tie downs. Theses also serve as pulls for the top slides.
Last edited by tlhicks; 04-08-18 at 05:45 PM.
The following users liked this post:
tlhicks (10-22-18)
Thread
Thread Starter
Forum
Replies
Last Post
jdanielca
LS - 4th Gen (2007-2017)
16
10-26-18 11:43 AM
PlotPoint
LS - 1st and 2nd Gen (1990-2000)
5
03-22-16 01:58 PM