Chrome Shift Gate Bezel Rattle
Thread Starter
Driver School Candidate
Joined: Jul 2002
Posts: 25
Likes: 2
From: Dallas, TX
Chrome Shift Gate Bezel Rattle
I've finally located the persistant, annoying rattle in my '02 UL 430. It's the dang chrome bezel around the shift gate. If I lightly press on the left side near the Neutral area, it goes away. So I need to take that thing off and put some kind of padding behind it. I've search the forums but have not found how to do this. Does anybody know if it's possible to remove just this piece, or do I need to remove the whole center console wood covering that it's attached to?
CL Community Team
Joined: Sep 2009
Posts: 3,916
Likes: 227
From: Alabama
search for the ashtray replacement console removal threads - there are pics there discussing how to take the wood console and shift bezel off. You probably should remove and detail clean it all and then see if anything is loose or not fitting well. May just need some foam tape applied at strategic spot or two.
Driver School Candidate
Joined: Jun 2011
Posts: 7
Likes: 0
From: TX
I had a Similar rattle on my LS430...With a thin flat screwdriver covering with electrical tape...i went around all four corner by popping it up...then pull the chrome bazel out and covered it with felt tape...and put back all together....
No rattle at all...as felt tape damped the noise.
No rattle at all...as felt tape damped the noise.
Thread
Thread Starter
Forum
Replies
Last Post
kg19989
LS - 3rd Gen (2001-2006)
15
Mar 30, 2010 10:51 AM
