Retracting Steering Wheel Made A Noise...
#1
Lead Lap
Thread Starter
Join Date: May 2006
Location: Ca
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
Retracting Steering Wheel Made A Noise...
This morning when I turned the car on, the steering wheel made a squeak/grind noise. I turned the car off and it made the same type of noise when it retracted. It did not do it again when I turned ignition on and off a few times.
I still have about 1.5k left on my warranty.
Any ideas?
I still have about 1.5k left on my warranty.
Any ideas?
#5
I had the same noise issue. The dealer installed some sort of clip to hold the wires up or something like that. No more noise. Its eery quiet, you just see the steering retract with no noise at all. It was done under warranty.
#7
Lead Lap
Thread Starter
Join Date: May 2006
Location: Ca
Posts: 518
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#10
LS430 owner's manual says it can be turned off by the dealer, via OBD port. I wonder if you could pull the connectors to the motor without throwing a check-engine light? (truck?)
#11
On the LS, generally the dealer needs to do it unless you have special equipment. I suspect it's the same on the LX, but you may try posting the question over there.
Thread
Thread Starter
Forum
Replies
Last Post
Dunhill421
NX - 1st Gen (2015-2021)
1
07-04-15 11:51 AM