my audio journey into crazyness.....
12-30-11, 10:27 PM
#1
my audio journey into crazyness.....
been 7 days of work here and there and im still only 70% done :/. it will probably take another month for me to finish this project but im in no rush. I hope this becomes very helpful for anyone interested in install car audio into their ls400. i'm a crazy audio head so i tend to go all out. I haven't really seen anyone post up a full fledged build. i always like to be hands on. If anyone has any questions feel free to ask.
Minor cabling
Hasn't gotten to crazy yet
One door open!
Second door open!
Third door and more parts falling off
some how all this stuff ended up in my garage xD
do you guys think im crazy yet
more pretty wires xD
its alive!!!
should i call an electrician?
Minor cabling
Hasn't gotten to crazy yet
One door open!
Second door open!
Third door and more parts falling off
some how all this stuff ended up in my garage xD
do you guys think im crazy yet
more pretty wires xD
its alive!!!
should i call an electrician?
12-30-11, 10:32 PM
#2
a 6.5 inch speaker say whaaaa 0_o
cutting fun
the rears not so fun at all
the speaker looks comfy now
one door together finally after so much labor cutting,fitting, and screwing in the speaker. any one see the tweeter kekekeke
all the wires sitting in the trunk for now
cutting fun
the rears not so fun at all
the speaker looks comfy now
one door together finally after so much labor cutting,fitting, and screwing in the speaker. any one see the tweeter kekekeke
all the wires sitting in the trunk for now
12-31-11, 05:49 AM
#4
Man, you are going H.A.M. on that setup. I wish I could hear the end results.
12-31-11, 07:47 PM
#6
Nice start. Take a look at my post in the audio setup thread and I might have even started a new thread on my build.
Eclipse AVN5510
Hybrid Audio Technologies Clarus 61-2
Stereo Integrity BM MKiii x 2
Massive Audio NX5
You might want to deaden the doors before you put the cards on. I found the exterior door caps rattled without it.
I deadened the crap out of the trunk as well. I still need to do the wall behind the rear seats and the floors this winter.
Eclipse AVN5510
Hybrid Audio Technologies Clarus 61-2
Stereo Integrity BM MKiii x 2
Massive Audio NX5
You might want to deaden the doors before you put the cards on. I found the exterior door caps rattled without it.
I deadened the crap out of the trunk as well. I still need to do the wall behind the rear seats and the floors this winter.
03-21-12, 12:29 AM
#7
Nice start. Take a look at my post in the audio setup thread and I might have even started a new thread on my build.
Eclipse AVN5510
Hybrid Audio Technologies Clarus 61-2
Stereo Integrity BM MKiii x 2
Massive Audio NX5
You might want to deaden the doors before you put the cards on. I found the exterior door caps rattled without it.
I deadened the crap out of the trunk as well. I still need to do the wall behind the rear seats and the floors this winter.
Eclipse AVN5510
Hybrid Audio Technologies Clarus 61-2
Stereo Integrity BM MKiii x 2
Massive Audio NX5
You might want to deaden the doors before you put the cards on. I found the exterior door caps rattled without it.
I deadened the crap out of the trunk as well. I still need to do the wall behind the rear seats and the floors this winter.
Trending Topics
03-21-12, 12:40 AM
#9
the air ride is back 
time to run more wires!!!
got to make sure to weld/solder all them wires so they dont come loose
the air ride fully in!!!!
wire looming all the wires that i ran throughout the car!!!! accuair whaaaaaaa
wire management
how the trunk is going to sit until i can get my hands on a lot of wood!!!
time to run more wires!!!
got to make sure to weld/solder all them wires so they dont come loose
the air ride fully in!!!!
wire looming all the wires that i ran throughout the car!!!! accuair whaaaaaaa
wire management
how the trunk is going to sit until i can get my hands on a lot of wood!!!
Last edited by PK_Celsior; 03-21-12 at 12:51 AM.
03-21-12, 11:54 AM
#14
thank you!! i cant wait to finish!! i feel like i've been working on my car forever 
yes UAS air on tein cs v2 they hold up very well!! hit a couple of pot holes pretty hard lol......maybe later down the road switch to either megan or bc to see if i can lay frame 
yeah i tend to do a lot of the work my self i rarely trust anyone else to touch my car xD
If you look in the engine bay you will see a big grommet going into the firewall. This grommet houses all of the main wires that plugs directly into your ecu and etc. i ran my power wire through that grommet. just poked a hole and pulled it right through very very slowly making sure my power wire was straight 
i really did not want to drill a hole through my firewall. If i chose too i probably would of taken a lot of the dash out just to play it safe!!!
you can see the big grommet on the left in this picture
yes UAS air on tein cs v2
they hold up very well!! hit a couple of pot holes pretty hard lol......maybe later down the road switch to either megan or bc to see if i can lay frame yeah i tend to do a lot of the work my self i rarely trust anyone else to touch my car xD
i really did not want to drill a hole through my firewall. If i chose too i probably would of taken a lot of the dash out just to play it safe!!!you can see the big grommet on the left in this picture