Need urgent help with my ucf10 / ls400
#1
Rookie
Thread Starter
Join Date: Apr 2011
Location: Traphouse
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
Need urgent help with my ucf10 / ls400
Hey everyone i was wondering how do i remove the bottom portion of rubber on the lowest part of my ucf10? Like the black part? heres some pics
I tried a little bit to rip it off hahah but i doubt thats a right way to do it
I tried a little bit to rip it off hahah but i doubt thats a right way to do it
#4
Pole Position
That rubber piece is attached on the inside of door outside moulding (panel) with rivets. This is from my 93 manual; To take off the panel on the front door you need to
remove 2 screws from inside lower door panel. (rear door is 2 screws, 1 nut) Using a moulding remover, pry out the moulding from the lower side. (manual says upper side but that's wrong)
Drill out the rivets
Remove rivets.
Install is reverse
remove 2 screws from inside lower door panel. (rear door is 2 screws, 1 nut) Using a moulding remover, pry out the moulding from the lower side. (manual says upper side but that's wrong)
Drill out the rivets
Remove rivets.
Install is reverse
#6
Pole Position
Well, he did post at midnight so . Don't want to get scratches on the door in the middle of the night. (Idk exactly where he's from though)
Trending Topics
#8
Rookie
Thread Starter
Join Date: Apr 2011
Location: Traphouse
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
hahah thanks everyone and i was trying fix my car up as fast as i can... so i guess its not really urgent :/ but thanks again! ill try all methods you guys recommended
Thread
Thread Starter
Forum
Replies
Last Post
doodoo
LS - 3rd Gen (2001-2006)
4
04-07-15 01:25 PM