Courtesy of fellow member "Suneet"
#6
Lexus Champion
iTrader: (6)
Join Date: Nov 2002
Location: Mississauga,Ontario,Canada
Posts: 3,488
Likes: 0
Received 8 Likes
on
8 Posts
Here is a tip to make the aftermarket ones look much more professional and high end.
Tape a thin black mask line for each section of red and clear so it matches the factory ones and gives the lights some depth.
Tape a thin black mask line for each section of red and clear so it matches the factory ones and gives the lights some depth.
Trending Topics
#11
Lead Lap
Thread Starter
Interesting idea...so just run a black strip of tape over the silver part that separates each part of the lens?
#13
Lexus Test Driver
I'd rather get some vinyl strips rather than just some black tape... unless you can find some tape that doesn't look too......"tapey"
should look good though
should look good though
#14
Lexus Champion
iTrader: (6)
Join Date: Nov 2002
Location: Mississauga,Ontario,Canada
Posts: 3,488
Likes: 0
Received 8 Likes
on
8 Posts
LOL
You guys are funny and i am stupid for not explaining it better.
I meant to mask off the area with tape and spray paint it gloss black to define the separations .
Using tape instead would make them look even more cheap.
You guys are funny and i am stupid for not explaining it better.
I meant to mask off the area with tape and spray paint it gloss black to define the separations .
Using tape instead would make them look even more cheap.