Windshield washer motor
#1
Pole Position
Thread Starter
iTrader: (1)
Join Date: May 2002
Location: Toronto/Vancouver Canada
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
Windshield washer motor
I have a 93' Lexus LS400, and my windshield washer does not work anymore. The ones for my headlights work, but when I press the button(located on the right side of steering column off the wiper lever) to activate the washer fluid, the wipers just move and nothing is coming out. And of coarse the washer fluid tank is topped up. So anybody experience this problem? or how much will it cost to obtain and have the motor replaced and where it is located under the hood? Anything I should look at first to remedie the situation? (under the hood or under the driver side dash for fuses, relays, etc...) before it will be taken to the dealrship.
Last edited by Darkside; 01-05-04 at 10:26 PM.
#3
Lexus Champion
Take out the reservoir and check the connection hose to make sure that it didn't clog up some how. If it's fine then you need a pump.
Last edited by SharpLS-96; 01-07-04 at 11:04 AM.
#4
When pressing the washer button, do you hear the washer pump engage? If you do, then it can also be that your squirters are clogged from wax or something. Or like SharpLS-96 said a blockage in the water lines. If you don't, your pump is out.
#5
Driver School Candidate
Join Date: Apr 2008
Location: Texas
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
How do you replace windshield washer hose on a 98 LS 400?
How do you replace the hose that runs from the hood hinge to the winshield washer pump on a 98 LS 400? The hose leaves the washer pump and goes behind the fender well. I am not sure if you should attack the problem from the top or bottom of the car? Can you just join a new hose to the hose at the hood hinge and pull it through to the pump?
Thread
Thread Starter
Forum
Replies
Last Post