2IS Amp Wiring
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2010
Location: TX
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
2IS Amp Wiring
Thinking about running an aftermarket sub in my 2IS. I have not looked at the factory amp nor have I looked at the firewall, but I haven't found answers to these questions in all my searching.
I have the non-ML, non-Nav system. Is there an amp for the speakers and an amp for the sub? Or one amp for both? Or one amp just for the sub?
Can I simply cut the power to my factory amp to run power to my aftermarket amp, or do I need to run a new power wire from the battery? Where does everyone go through the firewall? And are there existing holes behind the rear seat to get power into the trunk?
And I know I need the low frequency signal converter, what wires am I looking to attach that to?
My plan is to run this until I put the FlyAudio unit in, at which point I'll use the pre-outs from that.
Thanks for the help!
I have the non-ML, non-Nav system. Is there an amp for the speakers and an amp for the sub? Or one amp for both? Or one amp just for the sub?
Can I simply cut the power to my factory amp to run power to my aftermarket amp, or do I need to run a new power wire from the battery? Where does everyone go through the firewall? And are there existing holes behind the rear seat to get power into the trunk?
And I know I need the low frequency signal converter, what wires am I looking to attach that to?
My plan is to run this until I put the FlyAudio unit in, at which point I'll use the pre-outs from that.
Thanks for the help!
Thread
Thread Starter
Forum
Replies
Last Post
lex1997
Lexus Audio, Video, Security & Electronics
2
02-03-03 10:06 PM