New summer/track wheel set-up
#46
Lead Lap
iTrader: (6)
So many sexy square setups in here.
Here's mine: 18x10 ZITO ZF01 with 285/35/18 Sumitomo. I opted for 285/35 1 - because the width and we can fit it (with modded fenders, can actually fit 295 square believe it or not) and 2 - I wanted to keep the OD as close to 26.1" as I could.
Here's mine: 18x10 ZITO ZF01 with 285/35/18 Sumitomo. I opted for 285/35 1 - because the width and we can fit it (with modded fenders, can actually fit 295 square believe it or not) and 2 - I wanted to keep the OD as close to 26.1" as I could.
The following users liked this post:
BS ISF (04-09-18)
#48
Driver School Candidate
So many sexy square setups in here.
Here's mine: 18x10 ZITO ZF01 with 285/35/18 Sumitomo. I opted for 285/35 1 - because the width and we can fit it (with modded fenders, can actually fit 295 square believe it or not) and 2 - I wanted to keep the OD as close to 26.1" as I could.
Here's mine: 18x10 ZITO ZF01 with 285/35/18 Sumitomo. I opted for 285/35 1 - because the width and we can fit it (with modded fenders, can actually fit 295 square believe it or not) and 2 - I wanted to keep the OD as close to 26.1" as I could.
#49
Lead Lap
iTrader: (6)
ET 42. Probably could have gone more aggressive but it's fine.
Plenty of modding considering my ride height:
Rolled Fenders
Trimmed Fender Liners
Shaved Rear Fender Liner Studs
Shaved Quarter Panel Area where it meets the bumper.
Sounds like a lot but really isn't that bad. The grip is unworldly from stock so, totally worth it. I'll probably go for Michelin 295/35/18 after these for more grip and to be truly at stock OD.
Plenty of modding considering my ride height:
Rolled Fenders
Trimmed Fender Liners
Shaved Rear Fender Liner Studs
Shaved Quarter Panel Area where it meets the bumper.
Sounds like a lot but really isn't that bad. The grip is unworldly from stock so, totally worth it. I'll probably go for Michelin 295/35/18 after these for more grip and to be truly at stock OD.
#51
Driver School Candidate
I may have missed it, but do you rub at all with that setup? Stock height?
I'm looking at 18x9.5+35 and would like to run 275/35, square...I can't find a definitive post on if that will fit.
edit...I don't really want to do fender work
The following users liked this post:
RJMacReady (03-25-23)
#54
Moderator
Thread bump. These set ups look great. Function over form.
#55
Moderator
Did anyone confirm that 18x9.5 +38 will work with 275/35 square without fender mods? I want to try this size in RPF1s.
Thread
Thread Starter
Forum
Replies
Last Post
Mlbgoat
LX - 3rd Gen (2008-2021)
6
04-25-17 02:57 PM
KaiserSea1
SC430 - 2nd Gen (2001-2010)
21
09-01-11 02:50 AM