For those running it, what exactly are you using?

I was looking at the proton series NX kits,

http://www.nitrousexpress.com/20420-...lb-bottle.html

and then adding controllers separately. What controller do you guys use? RPM&WOT or something more advanced?

Honestly, Nitrous is a new world to me. So other than understanding how it works I don't know how to make a setup that's safe and functional. These motors are a lot more expensive than my 300zx or STi motors.

 

Run the jms chip controller! I'm going to be using it, it's installed and everything else was pieces other companies (nx Lightning solenoidss, zex nozzle, bottle

 

I use a nex system big foggers and shark nozzle, nex maximizer 4,all supporting options and soon nano.

 

You can pm me about stuff, or search and you will find lots of useful knowledge on a great setup. Mine was alil over $1200 but it's a really good setup, the controller is universal with many options of use that could be used on your 300zx or sti.

 

Haha I just mentioned those two because of I make a learners mistake it's only a couple grand to rebuild their motors. They're both turbod. They don't need nitrous.

I'll send you a pm here in a bit.

 

Dynotune Nitrous is the bang for buck kit IMO. I ordered their universal direct port kit. I plan to add my own electronics though.

Ideally I'm looking to use the NX Maximizer 4 especially since you can pair a wideband o2 to it