IS F clock replacement
for the ones of you who have white clocks- what year is your car? maybe the 2011+ have white clocks?
if they do, we may be able to source them and replace our green ones with the white ones by simply removing the centre dash console.
if they do, we may be able to source them and replace our green ones with the white ones by simply removing the centre dash console.
Yes the clock is annoying but forgettable for most of the time until someone points it out. Then it irks so bad all over again
I read somewhere that someone disliked the green clock so much that they put electrical tape over it.
To me what seems strange is the centre console lights up in typical 1990s Toyota green but the dash itself is bright white with blue needles.It would seem to me 1 colour would have been more consistent but it is what it is... Have I created another irk by pointing this out?
I read somewhere that someone disliked the green clock so much that they put electrical tape over it. To me what seems strange is the centre console lights up in typical 1990s Toyota green but the dash itself is bright white with blue needles.It would seem to me 1 colour would have been more consistent but it is what it is... Have I created another irk by pointing this out?
Yes the clock is annoying but forgettable for most of the time until someone points it out. Then it irks so bad all over again
I read somewhere that someone disliked the green clock so much that they put electrical tape over it.
To me what seems strange is the centre console lights up in typical 1990s Toyota green but the dash itself is bright white with blue needles.It would seem to me 1 colour would have been more consistent but it is what it is... Have I created another irk by pointing this out?
I read somewhere that someone disliked the green clock so much that they put electrical tape over it. To me what seems strange is the centre console lights up in typical 1990s Toyota green but the dash itself is bright white with blue needles.It would seem to me 1 colour would have been more consistent but it is what it is... Have I created another irk by pointing this out?
I noticed the two small holes, presumably to pull out the unit. Wonder if I should make up a quick 3D printed part and just cover up the clock and remove the holes for the hour/minute buttons.
Thread
Thread Starter
Forum
Replies
Last Post
Infamous3
GS - 4th Gen (2013-2020)
13
Oct 15, 2013 06:37 AM








