Borla Axle-back Exhaust - feedback thread
#33
Lexus Champion
iTrader: (9)
A cat back system will pass an emissions check just fine, because removal of the secondary cats will not upset any of the cars electronics. There is no electrical emissions check (o2 bung) after the secondary cats. However, if there is a visual inspection and the inspector knows what he/she is doing, you will fail the visual inspection. Remember it is against Federal and CARB law to tamper with or replace the working catalytic converters on a motor vehicle. And yes, I know, I am breaking the law, and so are a lot of other members of this forum.
Lou
#36
Intermediate
iTrader: (1)
The Borla axle back does have a decent start-up and idle sound, but the exhaust sound didn't seem to be all that noticeable while driving compared to stock. What I did notice is that around 2000 rpm under load that it had an annoying but not loud "drone' sound which was surprising to hear considering how quiet the exhaust was otherwise.
I tried drowing the droning with 2012 IS-F ML audio system, unfortunately it sux, does not play loud enough and the good low bass is lacking.
Last edited by jadeboy; 02-27-13 at 06:24 PM.
#37
Lead Lap
iTrader: (9)
The Borla axle-back cannot be "fixed" of this droning. Having some conversations with a few exhaust owners, it seems like the mid-pipe has more of an impact on overall sound. So you can't remedy the Borla axle-back of it's sound and drone. You either have to go cat-back, or....go custom crazy with what you have.
#41
Driver School Candidate
Join Date: Jan 2013
Location: ca
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
I just came from a buddies shop that fabs exhaust system for race cars and builds unreal motors as well. His place is called welding works. He all kinds kick butt cars at his shop today. He was going to build a custom exhaust but as he examined the F on his lift he was stating the stock exhaust is really good, very free flowing ect.. He said if I want a system build to improve sound just changing the mufflers is the most practical way to go. Even the the Y point you have mentioned here is well desighned.
#42
Lexus Champion
iTrader: (9)
^^^^I respectfully disagree. Though I never baselined my F with the stock exhaust, most stock Fs run about 335 to 340 RWHP. My F, with only a modified dual system utilizing non-modified stock mufflers, no secondary cats and with the factory manifolds put out 355 RWHP on a DynoJet. That was the baseline dyno run for me before my PPE headers, hi-flow cats and modified stock mufflers. I can't understand how that crush at the rear Y can be described as well designed.
Lou
Lou
#44
i guess the axle back has nothing to do with any of the CHeck engine light !!
Please tell me coz am really disappointed after my first full exhaust system ...
if no CEL then ill go for borla axle back
Please tell me coz am really disappointed after my first full exhaust system ...
if no CEL then ill go for borla axle back