Morning gents,

my car is in having my borla exhaust modified, and I wont have her for two days.

Does anyone know the width of the ISF front bumper? I'm looking at a carbon fiber front diffuser that I want to pick up, however I need to make sure it is wide enough (diffuser is 65" wide)

If one of you fellas are close to your car, and a measuring tape it would be greatly appreciated.

 

65in is not going to be wide enough from my measurements. The bumper is 66 1/2in and that is the very edge right before the wheel arch on both sides. I would think you would need a 68in wide diffuser.

I have some pics to upload for you as well here in a second.

 

I don't have a way to resize the images quickly here at work so just giving direct links to the full files.

I have a front lip on so I also took a pick of how far out the lip comes off the bumper which appears to be 1 1/4in from the very bottom edge of the bumper.

My measurements with my lip are that it is 70 1/2in so without the lip it would be 68 so you would probably need a 70in diffuser actually instead of what I previously said. Also with my lip my best estimate for how deep the deepest part of the bumper is from wheel arch depth to center point of bumper is 22in with my lip so 20 1/2in without.

http://jrphotodesign.net/isf/other/I...621_115711.jpg

http://jrphotodesign.net/isf/other/I...621_115804.jpg

http://jrphotodesign.net/isf/other/I...621_115906.jpg

 

10 char

meant to send you a PM