Rear roof spoiler and trunk spoiler
#16
Driver School Candidate
Damn that spoiler is super clean, any idea if I'd be able to sand it? Love everything except that when it elevates further down the middle, the angle is a bit sharp for my taste and think I would round it out (then paint of course)
#17
Intermediate
TRD
-Factory Prepainted
-Made of Urethane so it's nice and light, no warps
-comes with proper seals to minimize dirt and water from trapping inside
-according to TRD, the aero has been wind tested
-Factory Prepainted
-Made of Urethane so it's nice and light, no warps
-comes with proper seals to minimize dirt and water from trapping inside
-according to TRD, the aero has been wind tested
#18
Sharp looking, is the TRD company decal removable? right now im just looking but i also found a ARK fender but the cost is almost $300.00. If you all dont mind what did you pay for these trunk fenders?
#21
Pole Position
#23
Pole Position
MV Tuning Spoiler.
#29
Pole Position
#30
Pole Position
3M Super Strength Molding tape is the best option. It says stage 2 on the packaging. This together with 3M adhesion promoter and you shouldn’t have any problems. I did my spoiler with it a week ago and it stuck on instantly and would not budge at all didn’t even have to wait for it to cure. You shouldn’t even have to really apply pressure with this one tbh but it wouldn’t be a bad idea.