When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
All, I had a hard time pulling out the footwell lights too.... then I went and cut a 6inch piece of duct tape, wrapped the tape around the bulb up in there, and pulled.... pulled right out without any struggle or effort really.
never ceases to amaze me the uses for duct tape people come up with
All, I had a hard time pulling out the footwell lights too.... then I went and cut a 6inch piece of duct tape, wrapped the tape around the bulb up in there, and pulled.... pulled right out without any struggle or effort really.
Thanks for the tips. I didn't think of using the duct tape for that. I think this is a better and quick way than what I did.
Yes, duct tape method works to help get a grip on the bulbs. Since the footwell bulbs cannot be turned off and they do heat up quickly, a pair of rubber gloves may help when removing the hot factory bulbs (tiny).
Yup - Duct Tape works good - turn the lights off with the interior light control left of the steering wheel (up and down arrows) and no melting the duct tape.
here's mine, bought my LED's from Superbrightleds.com and HIDpowerhouse.
all the bulbs are 194/168, you don't need to go with "packages". I just popped off the lens for the footwell lights, it wasn't bad.
I think this is a better and quick way than what I did.
