I bought an Ikon motorsports rear diffuser a while back but have been way to busy to get to it. This past weekend I tried to mock up the fit and was surprised at how poorly the sides fit. I don't think there is any way that double-sided tape will hold it. I'm not keen on drilling holes in the bumper so is there a better way to fit it or a better diffuser that fits better?

Thanks,
Jeffrey

 

That IKON rear diffuser is bulky. I got a universal diffuser from Ebay, cut off the fins and shaped them to fit under the car, used 3M double side tape.

 

Any chance you can provide a link? I've been searching ebay for "universal carbon fiber rear diffuser" and I can't find that item. Thank you in advance.

 

Just go to Ebay then type in search bar "universal rear diffuser" a lot will show up

 

I was searching for "carbon fiber diffuser" because I saw "carbon" on that third picture of yours =). Thanks much I found it.

 

Its plastic but I wrapped it in CF vinyl

 

Sweet tip. Thanks again and have a good weekend.