HELP! Does anyone know the part # for airmix servo?
#1
Driver School Candidate
Thread Starter
Join Date: Sep 2010
Location: ma
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
HELP! Does anyone know the part # for airmix servo?
My heater/ac won't shift mode between floor and vents. Only defrost mode works, so i'm trying to find the part# to replace it. Anyone have experience replacing this part, please help or share DIY tutorial. I found 2 servos from sewell and a few on ebay but the part numbers don't match.
87106H 8710630430 SERVO SUB- SERVO SUB-ASSEMBLY, DAMP ASSEMBLY, DAMPER 2# (FOR AIRMIX) NO.1
87106H 8710630450 SERVO SUB- ASSEMBLY, DAMPER 2# (FOR AIRMIX) NO.2
http://www.ebay.com/sch/i.html?_trks...at=0&_from=R40
87106H 8710630430 SERVO SUB- SERVO SUB-ASSEMBLY, DAMP ASSEMBLY, DAMPER 2# (FOR AIRMIX) NO.1
87106H 8710630450 SERVO SUB- ASSEMBLY, DAMPER 2# (FOR AIRMIX) NO.2
http://www.ebay.com/sch/i.html?_trks...at=0&_from=R40
Last edited by xlinkx; 02-13-13 at 11:39 PM.
#2
Is the linkage going from the servo to the resirc hood intact? Many of us experience this after accidently forcing open the hood to change the cabin filter, which can break the linkage.
#3
Driver School Candidate
Thread Starter
Join Date: Sep 2010
Location: ma
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
No, my fresh air/recirculate button no longer work. I already threw away the broken linkage because I didn't know where it came from. My center and foot vents still work even after the broken linkage but after installing the flyaudio unit, it stopped working. The defrost light flashes for a few seconds after starting the car. No matter what mode I set it on, air will only blow out through the windshield. It should be an easy fix by following your DIY tutorial and replace one of the servo. I just don't know which servo need to be replaced.
Thread
Thread Starter
Forum
Replies
Last Post
OCLEX03
LS - 1st and 2nd Gen (1990-2000)
1
09-03-12 07:15 AM