How to do better job on yellow overlay on fogs?
#1
Driver School Candidate
Thread Starter
iTrader: (4)
Join Date: Oct 2010
Location: CA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
How to do better job on yellow overlay on fogs?
I have yellow overlay films for my 2011 Lexus IS. The fog lights are small/round as opposed to the rectangular ones from previous models.
I applied the overlay film directly on the fog and try to trim out the shape. It is a hard job as the fog lights are small. I got some small "wrinkles" afterwards.
For those of you who had done this before: Is there a way to disassemble the fog light so I have easier access to apply the film? Or, should I go with the "pre-cut films" that are easier to install?
Thanks!
I applied the overlay film directly on the fog and try to trim out the shape. It is a hard job as the fog lights are small. I got some small "wrinkles" afterwards.
For those of you who had done this before: Is there a way to disassemble the fog light so I have easier access to apply the film? Or, should I go with the "pre-cut films" that are easier to install?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Maxx941
ES - 1st to 4th Gen (1990-2006)
23
11-13-05 07:46 PM