projectdna

iTrader: (56)

no, unless you either 1. run stretched tires, or 2. roll/shave your fenders.

JrIS350

what size tires would you recommend if I go with those wheels?

projectdna

iTrader: (56)

to ensure max clearance, 215-40-18 and 235-40-18.

JrIS350

thanks for the info. I'll be looking into getting btwn high 30s and low 40 offset like you said at first.

supratkfy

projectdna

iTrader: (56)

the fronts will look more flush than the rear.

that 8.5 +50 in the rear is very close to OEM 18" wheel specs. you should be able to run mid- to low- 40's in the rear without fender mods if you're looking to run OEM-sized tires.

gse21S

06 is350. im thinking of going with works emotion cr2p 20x10 +20 all around. what size tires and do i need to worry about disk type? im willing to do fender mods, as i will be bagged. also link to anyone with specs close to these will will be super appreciated!

j3r

I have a 2010 IS250 RWD, what tire size would you recommend for the following setup?

Rotiform Ind-T wheels
F: 19 x 8.5 offset 35mm
R: 19 x 10 offset 40mm

JrIS350

you can go with 225/35 and 255/35

gse21S

been researching and looks like maybe A disk is fine. as far as tires, thinking about 255/35 all around. does that work? or would i need smaller in fronts?

JrIS350

if your car os a AWD you need the tires to be the same size. You might have to go very stretch for the front

JrIS350

Here is a thread with after wheels so you have an idea of the setups. https://www.clublexus.com/forums/is-2nd-gen-2006-2013/201509-aftermarket-wheel-owners-post-your-setup.html

gse21S

its RWD. reason for square is so all the wheels have the concave and lip. if i go staggered, only the rears will be concaved but both front and rear will be lipped. but thanks for the info. ill keep looking.

projectdna

iTrader: (56)

doesn't matter if you're on air. with your proposed wheel and tire specs, you will not be able to run 255/35-20 all around unless you want to taco your fenders as soon as you air down.

for the fronts, you will need to roll and slightly pull your fenders, and shave your fender you might even need to shave them down afterwards for that extra bit of clearance. with all that, go with 225/30-20, nothing wider or taller.

for the rears, you will need to roll your fenders flat. the natural pull of fender rolling should be enough to create clearance. you can run a square tire set-up, but i'd at least go with a 235/30-20, maybe even a 245/30-20.

jORPUZ

I want to get AG M310 wheels for 2006 IS350 (stock everything basically).
The specs are:
- [Front = 8.5x18 +35], [Inner clearance = 4 mm more, Outer position extended 16mm]

- [Rear = 9.5x18 +40], [Inner clearance = 14 mm less, Outer position extended 24mm]

My main concern is less inner clearance for the rear wheel - will this cause any problems or will it fit just fine?