jerom332

I bought a HID kit 9006 for my fog lights but the problem I am having is that the bulb seems to be a bit longer than the standard 9006 so the bulb wont screw in. Has anyone else had a similar problem? If so how did you get around this? If you dont have this problem please let me know where I can get bulbs similar to the ones you are using!

almacruel

I got my from XenonDepot.com the fitment was a little tight on one side but i was able to turn it in place...

cliffud

iTrader: (3)

I've had several customers pick up HID fogs for their second gen ISs and none of them have had a problem.

If you just want bulbs - $60 shipped!

http://www.mobilehid.com/cl.htm

Thanks!

Clifford

pocky

iTrader: (12)

Zero problems with mine. Got it from Cliffud.

is250rida

thanks for the quick shipping cliffurd!! got my h11s yesterday and installed! woohoo!!

TLe2006

same here i had to trim down the edges to turn it in.

Brian231

Make sure to install the bulb flush an not on an angle. It should turn to loosen and turn to tighten. Due to the plastic wheel well housing, it may be tricky to get a good view.

ba-b4

no problems with mine went in perfectly.. I have the xenondepot xtreme hid's for the fogs

ek9vboi

iTrader: (3)

I have a GS, but yeah no problems here.

T4styPh0

iTrader: (2)

On my IS250 had no problems and it was an ebay kit.

mlee21

i had some problems with the right side, ( if your facing the front of the car) but eventually got it to fit somehow.

weesped

iTrader: (8)

did you take off the bumper when you tried to install the bulbs? when i first tried to change my fog bulbs to just 2500k bulbs it wouldnt go in. and i swear those were shorter than my 3k HID bulbs but since i took off the front bumper to put in the HID's it went right in

jerom332

Thanks for the feed back guys!

cliffud

iTrader: (3)

I aim to please!

blklexo818

iTrader: (1)

wow i so need this thread, i just tried to put on the hid kit, well i did but the bulbs arent flush, its a mcchulloc 8K kit, the bulb would notttt turn at all into place...i somehow managed to get it in but its literally half assed, gatta redo it and take off my bumper for ez access and somehow make my bulb fit...anyone got ideas on how to make the bulb fit?