Do we have any Lexus Technician in the house? How does the air bag sensor works on the pass side? We took the entire seat apart and couldn't find the sensor but when we sat on the seat it works. Scratching our heads...

 

I put the switches underneath so their not on the center console like factory.

 

my lord, you must have a lot of time on your hand.
I am guessing the sensor is in the floor and not in the seat itself.

 

We started by 6pm and we were done by 10:30pm. Little difficult seen is our first GX. We done a lot Siennas, 4Runners, ect...

 

Hey how the hell you guys are writing so normal? Font size...

 

Impressive! Nice work!

If I may ask, how much $$?

 

Nice job.


It must be the way your device is showing what you typed.

 

The 2 pieces run you about $100. Comes with wires and switches. Labor was two of us. It was our first so took a little longer to take away everything very carefully.





No matter how careful you are with this back pieces. You always break on or 2 of this clips. $3 a piece
Thanks Tecman.

 

dude nice job. I was wondering if this was a job I could tackle DIY but these pics are a little daunting lol

 

Thanks!
Your have to know your way around electronics and take stuff apart.
And back on...lol
I just noticed. you in Texas... heated seat?

 

Hey sometimes it gets cold down here!

 

Angleslex, a few questions:

-I have the heated pad kit and intend to do this install. In your picture gallery here, haven't you taken the seats apart more than is needed to do the basic install of the heating element? What I mean is can't you sort of peel back the seat cover 1/2 way without completely disassembling the base?

-Also on that back plate, what's the method? I think there are 2 screws on the bottom and then it slides? Do you memember which direction it slides?

 

Wow I hope all that work paid off

 

It was easier for us to take the seats out.
You will be able to do the whole bottom and back. Easier to run the wires.
Yes. It was worth it.
Happy Wife happy life

 

I did the driver's seat. It's do-able, but kind of a pain. My car is a 2014 base...These pictures might help...







These two clips are at the top of the back plate, there are no screws. It's a push-and-slide approach here.






Back of the seat with back plate taken off












it's pretty easy to install this heater without taken the cover off completely




There are some hog rings here under the seat, take a picture, it is a bit complicated