DIY: How to take apart headlights for installation of accesories and removal of parts
#17
Advanced
iTrader: (13)
Nice write up man. I would've also done the tsx-r lenses from theretrofitsource clear lenses instead of the Fresnel lenses help the light output a lot. Also I believe it is ok to leave the levels in the headlights, I haven't had a chance to do it on my 3GS yet but in my 2GS I left them in and they were fine.
Last edited by kuWuPt; 12-28-12 at 01:17 PM.
#19
Driver School Candidate
Thread Starter
#20
Driver School Candidate
Thread Starter
Nice write up man. I would've also done the tsx-r lenses from theretrofitsource clear lenses instead of the Fresnel lenses help the light output a lot. Also I believe it is ok to leave the levels in the headlights, I haven't had a chance to do it on my 3GS yet but in my 2GS I left them in and they were fine.
#21
Driver School Candidate
Thread Starter
Update: Started to get a little moisture in my drivers side headlight, while my passenger side has none. Make sure you take the time and reseal it well...I had to go back and reseal it, it seems fine now!
The following users liked this post:
skur (06-16-23)
#25
Driver School Candidate
Thread Starter
#28
Driver School Candidate
Join Date: Jan 2014
Location: la
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
So i Screwed up the lights....
as i was trying to align/ raise them, i did passenger side perfectly but driver side was very off. so first i tried to bring it back to factory settings so the gauges can look normal. bolt B was stripped so i was using a socket and while turning it counter clockwise all of sudden i heard a noise and light dropped. i think the bolt is completely unhooked...any suggestions for an idiot like me? because I am too broke to purchase a new headlight at the moment! any help will be appreciated!!!