When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
MrMark, your car is amazing . Do you have problems e.g rubbing, allignment problem, vibration, etc with this stance?
seems like your wheels are more aggressive than this g35 wheels, huh?
What are the lip sizes on your wheels?
his wheels aren't much more aggressive than g35 coupe wheels in terms of outboard offset. they are relatively similar to what i had on my sc430 (which is close to what g35 coupe use)
The specs you posted are not that aggresive also a 275 tyre on a 9.5 is oversized, no stretch at all for a aggressive setup..
8.5 & 9.5 is not aggressive put the same offsets on a 9 & 10inch plus rim and then were getting somewhere..
If the specs are anything like these they will fit with only rolled guards, and trim of bumper location tab in the rear.
And you still will be atleast 10-15mm away from being flush.
well, its just the specs i copied & pasted from g35 forum, just to give an idea what OP's up against. like MrMark said, it really depends on how much you wanna roll, stretch, pull, whatever... i guess aggressiveness is pretty subjective since some members here find any modification to fender to be aggressive enough. OP mentioned 10.5" rear, even low 20's will require a lot of work..
his wheels aren't much more aggressive than g35 coupe wheels in terms of outboard offset. they are relatively similar to what i had on my sc430 (which is close to what g35 coupe use)
Mr Mark has a very nice set up. Really like the fitment on the rear. Too much for my DD but man it looks sick! That tire looks like a 295 on the rear and not a 285.
Mr Mark has a very nice set up. Really like the fitment on the rear. Too much for my DD but man it looks sick! That tire looks like a 295 on the rear and not a 285.
Thanks....the original tires were 295's, but I swithced to 285 due to fitment, I went down to a 285. The picture was after we switched to the smaller width.
The seller couldn't find the receipt (to look up the offset directly from the wheel maker). Also, I have asked a person from ISS Forged (a really friendly guy ) for his opinion and he said that it probably won't fit even with lots of camber-ing. So, yea I guess I'll look for another one then.
Mr mark your car is off the hook, how many sets of wheels did it take to get it right? there are very few cars that are fitted as well as yours we didn t get off on the right foot but i give props when props is due!!!