White fog lights??
wouldn't it just have been cheaper to take the bulb out and smash it from the inside?
Last edited by sakataj; Sep 30, 2010 at 10:28 AM.
Thread Starter
Lead Lap
iTrader: (1)
Joined: Sep 2008
Posts: 546
Likes: 0
From: The Netherlands, Europe.
yellow for the mother$&^*@#! win
forget the KGB, are they even around? plus my mother side is straight from russia, i have "connections"
rattle it out or vacuum it out. much better options then cutting into the fog
forget the KGB, are they even around? plus my mother side is straight from russia, i have "connections"
rattle it out or vacuum it out. much better options then cutting into the fog
Driver School Candidate
Joined: Jun 2010
Posts: 43
Likes: 0
From: Russia
oh yea
Yes and i have clear foglights.
Little DIY to Clear your foglights. Total time 20min from undoing the first screw and putting them back in again. This is the cheapest
way to have clear foglight.
So take out your foglights with undoing the 2 screws.
Then take them to a beanch and cut the topsite open.
Then whem you open the top you see the yellow tube, take something to smash it with and throw out all the lose glass pieces and you have clear foglights.
Then take the bite you've cut out and weld it back in.
Little DIY to Clear your foglights. Total time 20min from undoing the first screw and putting them back in again. This is the cheapest
way to have clear foglight.So take out your foglights with undoing the 2 screws.
Then take them to a beanch and cut the topsite open.
Then whem you open the top you see the yellow tube, take something to smash it with and throw out all the lose glass pieces and you have clear foglights.
Then take the bite you've cut out and weld it back in.
dont do this...just put a nutdriver in there and break the capsule then remove the glass.
in the first pic u can see my nut driver in there without a bit in it of course
Last edited by sakataj; Nov 8, 2010 at 02:58 PM.
