When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So are the fender liners there only for cosmetic purposes then? Such as hiding the sheet metal in the wheel well? Nice work with the hole saw. I used that once with a drill press and took me forever to cut out some metal.
Mine hits so much so I have marks to know where to drill. I'm just afraid of doing it. Hey Henry, wanna help me do mine? You don't have to accept any liability.
There you go, that's the way you should have done it, heheh. Ride around town for a little bit, and the marks would have been made for you!! Good job tho, took a lot of guts!!
Drilling itself isn't hard. It's not rocket science, but at the same time, you want to drill the hole ONCE and only ONCE. Wouldn't want to be off by a few inches and have to drill another hole again