GS300 engine has wobbly pulley???
#1
GS300 engine has wobbly pulley???
Hey guys,
I literally JUST posted about how I loved my car and that it has 187k on the odo with nary an issue and then I go outside to hear the serpentine belt kinda getting a little squirrelly on one of the pulleys.
Can you guys tell me what I can do to fix this if the pulley highlighted in green is a little wobbly Just change the serpentine belt? (hasn't been replaced in probably 60k miles)
TIA
Clifford
I literally JUST posted about how I loved my car and that it has 187k on the odo with nary an issue and then I go outside to hear the serpentine belt kinda getting a little squirrelly on one of the pulleys.
Can you guys tell me what I can do to fix this if the pulley highlighted in green is a little wobbly Just change the serpentine belt? (hasn't been replaced in probably 60k miles)
TIA
Clifford
#5
Lexus Test Driver
iTrader: (8)
and in probably a rare occasion, a snapped shaft.. Happened to me twice! (different car) but now that I think about it, it wouldn't be wobbling if it were snapped! so yea duh its the bearing! ha ha sometimes I gotta say to myself what I'm thinking before I really know what I'm saying
Last edited by Mr Jokster; 10-16-08 at 03:50 AM.
#6
can the bearing be replaced by hammering it out of the pulley and then gently hammering in a replacement?
i did this same thing on my belt tensioner pulley. the bearing went bad so i just went to get a $4 bearing and swapped it out. this was approx 60k ago.
i did this same thing on my belt tensioner pulley. the bearing went bad so i just went to get a $4 bearing and swapped it out. this was approx 60k ago.
Thread
Thread Starter
Forum
Replies
Last Post
avalon42
LS - 1st and 2nd Gen (1990-2000)
5
03-09-08 06:02 PM