Traded in my old HS250h for a 2014 ES300h. When I entered a destination in my old HS300h GPS, the display showed approx. number of miles to destination and approx. time of arrival @ destination. The display on my ES300h also shows miles to destination, but shows approx. amount of time (hours, minutes) to destination rather than ETA. Any way to change the Nav display settings to show ETA rather than amount-of-drive-time-remaining?

 

Not positive but try clicking on the box that has that info in it, I believe it will toggle the info. BTW, I also traded my 2010 HS250h in when I purchased my new 2013 ES300h. The HS was a very good car but needed more room and the ES fits the need nicely.

 

Thanks! I'll try that. Agree wholeheartedly with your HS250h/ES300h comparison.

 

If you put your pointer in the box that says miles and click a box will come up to select eta.

 

Thanks for the help, y'all. It worked!

 

Just took first long trip in 2014 ES350. When you put in the destination it show a drive time say of 12 hours. When you compare this same route to goggle maps, it will show a drive time of say 9 hours. The nav unit does not really catch up until you are about at your destination...

 

You can adjust the "time to destination" by going into the navigation system settings for the type of roads that you are driving on. Depending on what changes you make, the time to destination will either increase or decrease.