disassembly of the ventilation panel ?
#2
Lead Lap
iTrader: (1)
Remove leather knee panels, remove center console plastic, remove center console cup holder section, remove shift ****, remove center console plastic, remove couple screws under the radio computer, pull out radio computer, remove screws from underside of clock assembly.
I think that's it lol.
good luck. I'll be doing this very soon also. You may need to also pull the gauge cluster shade away a tiny bit but not remove it completely. Reason being i think there is a clip or screw rite near the start button.
I think that's it lol.
good luck. I'll be doing this very soon also. You may need to also pull the gauge cluster shade away a tiny bit but not remove it completely. Reason being i think there is a clip or screw rite near the start button.
The following users liked this post:
otakusan (08-23-17)
#3
Intermediate
Remove leather knee panels, remove center console plastic, remove center console cup holder section, remove shift ****, remove center console plastic, remove couple screws under the radio computer, pull out radio computer, remove screws from underside of clock assembly.
I think that's it lol.
good luck. I'll be doing this very soon also. You may need to also pull the gauge cluster shade away a tiny bit but not remove it completely. Reason being i think there is a clip or screw rite near the start button.
I think that's it lol.
good luck. I'll be doing this very soon also. You may need to also pull the gauge cluster shade away a tiny bit but not remove it completely. Reason being i think there is a clip or screw rite near the start button.
Thread
Thread Starter
Forum
Replies
Last Post
AL13NV8D3R
GS - 4th Gen (2013-2020)
6
01-14-16 02:01 PM
amati5
SC- 1st Gen (1992-2000)
27
11-20-01 09:20 AM