1995 M/T SC300: The Work Truck
#61
It was amateur hour at the body shop, but I got the fender mostly smoothed out and mostly bolted up.
I'll need to do up some sort of adapter to get the two bottom bolts to line up with something, but otherwise it feels very solid. The rear edge is pulled in a bit from the structural damage, so despite the bad panel gap, the door actually opens without rubbing or pinching the fender.
I cinched up the fender liner while I was in there. It was dragging on the tire when turning or going over bumps. Stupid lowered suspension.
Oops, wrong before pic...
I'll see about fixing up the recently flapping fuel line cover this afternoon, and maybe swap tranny mounts.
I'll need to do up some sort of adapter to get the two bottom bolts to line up with something, but otherwise it feels very solid. The rear edge is pulled in a bit from the structural damage, so despite the bad panel gap, the door actually opens without rubbing or pinching the fender.
I cinched up the fender liner while I was in there. It was dragging on the tire when turning or going over bumps. Stupid lowered suspension.
Oops, wrong before pic...
I'll see about fixing up the recently flapping fuel line cover this afternoon, and maybe swap tranny mounts.
Last edited by t2d2; 05-06-17 at 01:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
clean
Performance & Maintenance
5
05-16-07 12:41 PM