16 GS F-Sport (Obsidian) Round 2...
#61
big... every time i see tjhis pic of your car i am like wow.. this is a beauty... if you do not mind, what was the cost to black out your chrome? Also I just noticed that the area where you inserted your Apexi controller you must have customized it? Thank you for your time to make these mods, upload the great results and provide feedback! Also do you feel like the Apexi controller does anything?
#62
Thank you..
Blacking out the trim is going to vary from body shop to shop. I personally had all pieces removed and prepped before painted. To ensure best look/adhesion.
The Apexi throttle controller was installed without any modification. Very easy to install. In my opinion, & a must have for car enthusiasts. It offers you 7 different modes w/led changing color
with each mode selected.
Blacking out the trim is going to vary from body shop to shop. I personally had all pieces removed and prepped before painted. To ensure best look/adhesion.
The Apexi throttle controller was installed without any modification. Very easy to install. In my opinion, & a must have for car enthusiasts. It offers you 7 different modes w/led changing color
with each mode selected.
#63
Thank you..
Blacking out the trim is going to vary from body shop to shop. I personally had all pieces removed and prepped before painted. To ensure best look/adhesion.
The Apexi throttle controller was installed without any modification. Very easy to install. In my opinion, & a must have for car enthusiasts. It offers you 7 different modes w/led changing color
with each mode selected.
Blacking out the trim is going to vary from body shop to shop. I personally had all pieces removed and prepped before painted. To ensure best look/adhesion.
The Apexi throttle controller was installed without any modification. Very easy to install. In my opinion, & a must have for car enthusiasts. It offers you 7 different modes w/led changing color
with each mode selected.
Last edited by SRC350F; 04-26-16 at 03:14 PM.
#66
After lowering her, we went ahead and did the alignment. You can see the before measurements
as well as the after. We were unable to get the Rt front camber in specs at this time.
Will do a follow up alignment once things settle down.
To be continued..
as well as the after. We were unable to get the Rt front camber in specs at this time.
Will do a follow up alignment once things settle down.
To be continued..
Last edited by biggame; 09-21-19 at 10:02 PM.
#72
It's real easy! Open the glove box, then remove the front dash panel #5 from the diagram. (Installed with clips) Just slightly pull from glove box opening, working your way around. Then remove the lower 2 screws from the radio & then it should pull straight out. I would put a towel on your center console to protect it. Then remove the harness plug and install..
#73
big I forgot to ask did you use any spacers for when you used the springs?
I definitely plan to install those cameras just in case of any future hit and runs
I definitely plan to install those cameras just in case of any future hit and runs
Last edited by SRC350F; 05-08-16 at 08:32 PM.