02 LS430 Going Low

Reply Subscribe

Thread Tools

Search this Thread

Sep 5, 2013 | 10:25 AM

#31

levie

Lexus Test Driver

iTrader: (1)

Joined: Oct 2010

Posts: 1,492

Likes: 0

From: alberta

those wheels look awesome on a LS. exited to hear how the new set up runs!

Sep 5, 2013 | 10:43 AM

#32

HRDBDY808

Driver School Candidate

Joined: Jul 2013

Posts: 36

Likes: 0

From: HI

fakkkinn sickkk dude. im thinkin about gettin the same set.

Sep 5, 2013 | 11:14 AM

#33

Kira X

桜犯罪シンジケート

iTrader: (24)

Joined: Oct 2008

Posts: 11,698

Likes: 675

From: 東京都

It's looking great so far. How hard was it to pull the rear fenders and how did you do it?

Sep 5, 2013 | 11:45 AM

#34

LsBanGer43

Lead Lap

iTrader: (1)

Joined: Sep 2010

Posts: 493

Likes: 0

From: CA,707

Those fender cuts tho!?! looks like it'll hurt if you accidentally rub against it should have tooken your time cutting those to make them look cleaner but over all i like the wheels

Sep 5, 2013 | 08:30 PM

#35

PROSTAR

Thread Starter

Pole Position

Joined: Feb 2013

Posts: 361

Likes: 6

From: G-LAND

Quote:

Originally Posted by DriftGirl

Awesome!!!!!

thanks

Quote:

Originally Posted by levie

those wheels look awesome on a LS. exited to hear how the new set up runs!

runs good just rubs a little but found out what the problem was

Quote:

Originally Posted by HRDBDY808

fakkkinn sickkk dude. im thinkin about gettin the same set.

haha thanks dude

Quote:

Originally Posted by Kira X

It's looking great so far. How hard was it to pull the rear fenders and how did you do it?

well i went old school and used a pipe to roll not that hard to do just gotta to know when to stop

Quote:

Originally Posted by LsBanGer43

Those fender cuts tho!?! looks like it'll hurt if you accidentally rub against it should have tooken your time cutting those to make them look cleaner but over all i like the wheels

actually the cuts are clean its the paint that chip, but its ok like i said going to paint it soon

Sep 5, 2013 | 08:54 PM

#36

PROSTAR

Thread Starter

Pole Position

Joined: Feb 2013

Posts: 361

Likes: 6

From: G-LAND

well here's what the rubbing was found out the inner panel and the stud that sticks out to hold the liner so i hammered the panels and grind that stud off.

http://www.flickr.com/photos/38670456@N03/9571038223/

http://www.flickr.com/photos/38670456@N03/9571035845/
http://www.flickr.com/photos/38670456@N03/9573834864/
and no more Rub