The 16 and 18volt cordless drill were no bueno for the hole saw. When you drill holes to clear the upper control arm, try using a corded drill because that has constant power. I'm going to try the compressed air drill tomorrow

 

test fitted my wheels yesterday. this is the front so far. no roll or anything yet. 19x10 +15 (with spacer)

 

side view.



also picked up and installed some RCR LEDs today.



also is there anyway to get "light out" indicator in the cluster to turn off?

 

nice wheels! what's the final offset with the spacers? in other words what spacer size are you using?

as for the "light out" your tails should have been packaged with load resistors (assuming you bought them new). if not get a set of load resistors, i'm unsure as to how many you need, and install them. typically you need one resistor per bulb and our cars have 6 taillight bulbs.

 

Thanks! The wheels come out to be 19x10 +15 after the spacer.

Will do with the resistor, thanks

 

Wheels looks great!

 

Where are the updates ?!

 

nice job man. im jealous about your pace of work.

 

after all these months finally had the time and motivation to get working on my car.


screenshot tool

 

cleaaaan brooo

 

wow long time overdue but well worth it!

 

Nice! Excellent wheel choice.

 

Looking good Justin

 

Thanks everyone. Here's a side shot. Need to get an alignment now and change out my hideous bumper lights!


how do i print screen

 

new sub thread bump lol