Going under the knife again....(YaKuZa_GS build 2.0)
Fitment is definitely on point.
04-09-13, 03:47 PM
#94
Driver School Candidate
Join Date: Apr 2013
Location: bc
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
although I hate ur interior .... Those DAD logo seats... It's not my taste but ur passion for this car is amazing ... Keep up the good work !
Last edited by felixy69; 04-09-13 at 05:48 PM.
It's no biggie. I can't expect everyone to share my style or vision.
04-10-13, 09:53 PM
#100
I picked it up at a local shop not too far from me. I just checked the website and its actually a 4gal tank. Here's the link if youre interested.
http://www.kmstools.com/universal-ai...air-tank-18716
http://www.kmstools.com/universal-ai...air-tank-18716
Last edited by Sonic_RC; 04-19-13 at 09:51 AM.
04-14-13, 02:33 PM
#102
You have to remove the rear seat and the c-pillar panels, then the entire rear tray slides out. Then you would have access to the screws to remove the sub. They were probably just lazy. When I replaced my factory sub, I used the same location but I made a sub ring, so I could just remove the sub from the trunk.
04-28-13, 09:41 PM
#104
Check post #82Although I was originally quoted 2-3 weeks, its already been about 9 weeks due to them not coming back properly. Aparently this contours of the pieces are tricky and silver carbon is a lot harder to work with than the typical black. I sure hope this time they get it right.
Last edited by Sonic_RC; 04-29-13 at 07:12 AM.
