FS: 2JZ-GE Turbo Manifold. Tubular Stainless!
#1
FS: 2JZ-GE Turbo Manifold. Tubular Stainless!
Need to get rid of my old parts laying around. This tubular stainless 2JZ-GE manifold was used for about 3-4k miles in my car. I just sandblasted the whole thing to clean it up. Looks brand new now. It has a 1/8NPT hole pre-tapped in cyl 6 runner. You can see it in the picture. It's for your EGT bung. Cyl 6 usually runs the hottest so that's where I decided to place the EGT. If you decide not to use an EGT or you want it in a different location, just get a 1/8NPT plug from your local hardware store for $1.
Up for grabs $150 shipped!
Was used for my previous turbo setup. Pix below:
Up for grabs $150 shipped!
Was used for my previous turbo setup. Pix below:
Thread
Thread Starter
Forum
Replies
Last Post
93driftslu
2Gen GS430 / 400/ 300 Classifieds (98-05)
0
03-20-17 12:51 PM