WTB: Broken Sway Bar Endlinks & Repair Damaged ABS/VSS Sensors
#1
WTB: Broken Sway Bar Endlinks & Repair Damaged ABS/VSS Sensors
Ok, it might sound kind of strange for me to be asking, but if you guys have been looking in the GS Suspension section of the forum then you will know what I'm talking about.
Anyways, I'm trying to make upgraded sway bar endlinks . If anyone has a set of endlinks with a bent/twisted/broken center rod (yes the pencil thin center rod) then I want to buy it from you. However, my only request is that the ball joints need to be in good condition.
As for the ABS sensors with broken cables. I'm not looking to buy them, but if anyone has a sensor that has a broken cable, I will repair it for you. Seems kind of senseless to pay $200 for a whole new sensor when it's only the wire thats busted. Just PM me about it and we can setup an arrangement.
I'll even post up a DIY if I get a very badly damaged cable thats worth taking pix of. I already repaired the ones on my car so I'm not going to splice it open again just to take pix.
Anyways, I'm trying to make upgraded sway bar endlinks . If anyone has a set of endlinks with a bent/twisted/broken center rod (yes the pencil thin center rod) then I want to buy it from you. However, my only request is that the ball joints need to be in good condition.
As for the ABS sensors with broken cables. I'm not looking to buy them, but if anyone has a sensor that has a broken cable, I will repair it for you. Seems kind of senseless to pay $200 for a whole new sensor when it's only the wire thats busted. Just PM me about it and we can setup an arrangement.
I'll even post up a DIY if I get a very badly damaged cable thats worth taking pix of. I already repaired the ones on my car so I'm not going to splice it open again just to take pix.
#4
Lexus Test Driver
Hey Jeff, i have 2 front speed sensors damaged, not by foulty sway bar instalation, stretching or something else, all i know that suspention "guru" busted both while doing custom alignment few months ago on my car. PM me please with opinions/ideas
- Jake
- Jake
Thread
Thread Starter
Forum
Replies
Last Post