WA WTB: exhaust cut-out/tailpipe exit from a stock IS300 bumper, > 2 inches
#1
Driver School Candidate
Thread Starter
Join Date: Feb 2009
Location: wa
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
WTB: exhaust cut-out/tailpipe exit from a stock IS300 bumper, > 2 inches
I would like the exhaust cut-out/tail-pipe exit from a stock rear bumper, at least 2 inches surrounding the cut-out. Make some money off that wrecked rear bumper! (crappy that it's wrecked in the first place...)
I want (need) symmetry and the single exhaust outlet doesn't do it for me!! I want to take the piece you sell me and epoxy it into the hole I cut on the drivers side.
Yes, sounds crazy. I have seen it done, and is cheaper then having one formed out of fiberglass. And, it will match the passenger side perfectly!!
So, I don't know.. if you have a wrecked rear bumper you are about to throw away, saw zaw a chunk around the exhaust exit and put it in a box. I'll pay $50 for it. Thanks.
I want (need) symmetry and the single exhaust outlet doesn't do it for me!! I want to take the piece you sell me and epoxy it into the hole I cut on the drivers side.
Yes, sounds crazy. I have seen it done, and is cheaper then having one formed out of fiberglass. And, it will match the passenger side perfectly!!
So, I don't know.. if you have a wrecked rear bumper you are about to throw away, saw zaw a chunk around the exhaust exit and put it in a box. I'll pay $50 for it. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
CAMAracer
SC430 - 2nd Gen (2001-2010)
2
05-28-08 08:46 AM
TJW98LS
LS - 1st and 2nd Gen (1990-2000)
3
07-26-07 09:34 AM
BLiu
GS - 2nd Gen (1998-2005)
4
01-24-03 10:34 AM