When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I just had new front brakes put on my car and the tech lifted the front of the car by putting the lift pads on the inner rail/floor support beam under the car and not on the outside rail where it should go. I looked at the inner rails they don't seem to be bent, but I'm wondering if the inner rails are strong enough to be used as lift points??
Before I bought my race ramps, I always used the frame to jack the car up and I placed jackstands on the pinch weld points (per the manual). I never had any issues with anything bending or denting.