Soarer Badge Question
#1
Pole Position
Thread Starter
Soarer Badge Question
so i ordered a griffin badge and noticed the pegs don't line up with the existing holes. How do you guys have the mounted? Did you drill new holes or cut off the pegs? If you did cut em off, how so? And any house remedies for taking off this glue? Its sure is a pain
#3
Pole Position
Thread Starter
Thanks! What size bit did you use? I also noticed that lighter fluid works well too.
#4
Lead Lap
iTrader: (2)
You don't need the pegs on any badge; use a pair of wire cutters to cut them off and use a blade to level the surface down flush. Many badges from factory on tons of cars are applied using double sided adhesive. You'd want the thinnest adhesive tape, Wurth has it and probably 3M.
#5
Pole Position
Thread Starter
You don't need the pegs on any badge; use a pair of wire cutters to cut them off and use a blade to level the surface down flush. Many badges from factory on tons of cars are applied using double sided adhesive. You'd want the thinnest adhesive tape, Wurth has it and probably 3M.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post