Finally, the long awaited reverse Red/Clear tails DIY thread
#78
Pole Position
iTrader: (5)
I think about the only way to make that even remotely look "right" might be to candy red transparent paint the rest of that front lense from the inside, EXCEPT for a rounded off rectangle where the reverse light could shine through clear. As it sits that just looks... Wrong-- know what I mean? Too much stuff going on, and conflicting lines/angles.
Last edited by GZZ-TT; 05-29-12 at 02:49 PM.
#81
Pole Position
iTrader: (1)
@ScottURnot - I don't wanna high jack your thread, but I know you, @UZ-TT was doing some tail development and I can't find that thread.
I'm going with the ultimate clear lens. 97+ has those funky lines that the 95s has (but less) in the clear section.
· 95-96 - Just there for a test I dead. Clear lens over top leaving the tails: clear on the top 30%, and a clearER
Reverse, red, amber, red on the bottom
· 97-00 - Blacked out and ready for a clear lens.
· eBay - Using for a pure clear lens.
95-96: these will be sued to extend into the groove where the OEM tails seal. The ebay ones are a lot slimmer than I thought.
I'm going with the ultimate clear lens. 97+ has those funky lines that the 95s has (but less) in the clear section.
· 95-96 - Just there for a test I dead. Clear lens over top leaving the tails: clear on the top 30%, and a clearER
Reverse, red, amber, red on the bottom
· 97-00 - Blacked out and ready for a clear lens.
· eBay - Using for a pure clear lens.
95-96: these will be sued to extend into the groove where the OEM tails seal. The ebay ones are a lot slimmer than I thought.
Thread
Thread Starter
Forum
Replies
Last Post
Rock-a-Lex
2Gen GS430 / 400/ 300 Classifieds (98-05)
36
07-25-08 10:46 AM
Rock-a-Lex
GS - 2nd Gen (1998-2005)
28
11-15-07 07:59 AM