94_soarer

iTrader: (8)

Hey CL, i had a Greddy BCC & SCC laying around in my garage so i decided to wire them into my 1J SC300, i have a soarer m/t motorset, i have done alot of research on which wire goes where...and basically i have it all wired up, except one wire,

On the Greddy BCC there are 4 wires..
-Black wire: Power *Ground* (E1) on the Soarer Pinout
-Red wire: +12v *Power* (+B) on the Soarer Pinout
-Green wire: should go to the map sensor (PM1) on the Soarer Pinout

But i cannot figure out where the white wire goes....i have searched and found the previous threads wit the answers in it, but i jus need to find out where is the TPS wire on the Pinout???

This is one of the Pinouts i used...
http://www.supraforums.com/forum/att...3&d=1150327335

Please Help me out!!!

94_soarer

iTrader: (8)

wow, no one wants to help a brotha out???

bryan767

iTrader: (6)

adjust the voltage to 4.3 - take off the screws on the bcc to get to a inner screw that you will turn to adjust to the right voltage, put your neg leads onto the ground/earth/anything metal on/in the car and the positive leads on the minty green wire on the ecu side.

94_soarer

iTrader: (8)

I wired it in, and everything works jus fine!!!

Thanks Bryan!!!

Dr.Fate

iTrader: (1)

This should be a sticky!

94_soarer

iTrader: (8)

^^^ Tru dat

bryan767

iTrader: (6)

Thanks. Ill change the picture to the most recent one in a bit. It lists the pins for the wires aswell