ScanGauge Codes Oil & Tran Temps
02-19-13, 10:39 PM
#1
Rookie
Thread Starter
Join Date: Sep 2002
Location: Fl
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
ScanGauge Codes Oil & Tran Temps
I am trying to find the coding so a ScanGauge II will display engine oil temperature and transmission temperature for a 2009 RX-350 FWD. Various codes for these two parameters exist but I have found none that work because they seem specific for other models.
I live in Florida but am in upstate NY for an extended period. When I start the car and the temperature is in the twenties or even much lower I just wait an arbitrary 4 or 5 minutes for it to warm up somewhat. I would rather be smarter and watch actual temperatures.
The Scan Gauge does reliably display water temp but I think oil temperature would be more meaningful. Transmission temp is also important because I suspect it does not consequentially warm up until the vehicle actually gets underway.
I live in Florida but am in upstate NY for an extended period. When I start the car and the temperature is in the twenties or even much lower I just wait an arbitrary 4 or 5 minutes for it to warm up somewhat. I would rather be smarter and watch actual temperatures.
The Scan Gauge does reliably display water temp but I think oil temperature would be more meaningful. Transmission temp is also important because I suspect it does not consequentially warm up until the vehicle actually gets underway.
Thread
Thread Starter
Forum
Replies
Last Post
2013FSport
IS F (2008-2014)
5
05-08-19 08:02 AM