RX330 Suspension Mystery
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2014
Location: AZ
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
RX330 Suspension Mystery
06 330 4WD Replaced control arms, tied rod ends, ball joints and had aligned. Now it somehow appears that the suspension is stuck in the high position, there is no movement in the front struts. It sounds like there is no motion from any suspension components. Feeling a bit stupid here...everything looks correct. Any ideas would be greatly helpful. So Disconnected battery and suspension is actually active now. But each corner is at a different height, will not return to Normal or low position
Last edited by Jdawgg; 12-06-14 at 07:20 AM. Reason: Update
#2
When you post next time friend, be more specific. You failed to mention if you have air suspension or standard.
My guess is you either have an issue with your height sensors which are attached to control arms, or you have a leak in one of the struts. You could also have a problem with the valves that send the pressure to each strut though the first two are more common. I would also check to make sure the pump is functioning.
Make sure they reattached the height sensors to each control arm too.
My guess is you either have an issue with your height sensors which are attached to control arms, or you have a leak in one of the struts. You could also have a problem with the valves that send the pressure to each strut though the first two are more common. I would also check to make sure the pump is functioning.
Make sure they reattached the height sensors to each control arm too.
Thread
Thread Starter
Forum
Replies
Last Post
xfactor70
ES - 1st to 4th Gen (1990-2006)
16
06-18-10 09:24 PM
aparker813
ES - 1st to 4th Gen (1990-2006)
4
06-02-09 11:01 AM
Lexus082
Suspension and Brakes
10
11-23-07 12:32 AM