Car Jack for 2001 RX300
#31
Lexus Test Driver
This does not work well for me as my Jack stands have notch in the middle then flat shoulders and raised tips at the end, The frame rails sit nicely in the flats and the tips work as book-ends. But on the seam the tips contact the RX. Just could be an issue with the Jack stands,
Salim
Salim
#32
This does not work well for me as my Jack stands have notch in the middle then flat shoulders and raised tips at the end, The frame rails sit nicely in the flats and the tips work as book-ends. But on the seam the tips contact the RX. Just could be an issue with the Jack stands,
Salim
Salim
#34
#35
Moderator
#36
I prefer to use stands on the rails and lift by the frame or differential depending which end you lift. I would only use a slotted jack pad to use the factory pinch weld as a lift point, not for the purpose of support. That's just my preference. FWIW, im using the newer gray HF 3 ton stands
Here is a site that the reviews the Esco stands with a pic of them being used on a pinch weld. Unfortunately i didn't know they are priced individually. http://revlimiter.net/blog/2010/07/m...tand-review-1/
Thread
Thread Starter
Forum
Replies
Last Post