When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Mine just came in today..ill report back once I get them installed, but it might be a while. Its winter here and the car is hibernating. Headers look good, but im gonna clean up the weld slag before I put them on.
For those of you who have installed your headers, did you re-use the stock gaskets or buy new ones?
PPE should be starting production next week on my SC400 headers.
For those of you who have installed your headers, did you re-use the stock gaskets or buy new ones?
PPE should be starting production next week on my SC400 headers.
i bought new ones but my manifold ones were still good but i changed all to be on the safe side
Okay so while looking over my headers for the 100th time.(I cant wait to install these.) I found a small hole in one of the welds of the passenger side header. It big enough to fit about 3-4 mechanical pencil leads in so it's small but it will definitely cause and exhaust leak if installed. What should i do? Contact PPE about it or just have it welded over? This kinda sucks...
I hope PPE does what S&S did and pay for both way shipping. It's wouldn't be fair if you have to ship it back at your own cost just because they didn't complete the welds...
I suspect it's an isolated issue. I'm definitely going through mine when I get it. So far I'm not fond of the burr I've been seding around the O2 bung.